Full matrix capture (FMC) imaging through a non-planar surface is a time-intensive task, due to the need to calculate the time of flight from each transmit/receive element combination to a given pixel in the region of interest through the refractive boundary. Due to the computational complexity, data is often post-processed after the inspection. TWI Technology Centre (Wales) has developed a real-time FMC imaging system capable of generating full-focused imagery through a component of complex geometry where no prior knowledge of the profile is provided.
Leading innovation in non-destructive testing
FMC is a relatively new ultrasonic non-destructive testing (NDT) technique, used to image sub-surface flaws in test components. The main advantage of FMC over existing phased array techniques is its ability to generate fully focused imagery of components. It achieves this by firstly acquiring the full time-domain signal for every possible transmit/receive combination, and then discretising the region of interest into a finite grid. Every cell in the grid is treated as a focal point and represents a pixel in the final image.
This ability to acquire the full time-domain signal from every possible transmit/receive element allows for changes in focal requirements to be determined dynamically and after acquisition, as there is no ultrasonic focusing within the component (as in the case of phased array).
Achievements
This work developed algorithms which:
- generate fully focused imagery in real-time during the inspection from FMC data
- ultrasonically recognise and account for refractive boundaries between the ultrasonic transceiver and region of interest, to facilitate automated focusing and inspection through such boundaries
- offer a dynamic computationally efficient focal law calculator for systems containing refractive boundaries where the profile has not been provided
- produce high-quality imagery of components, allowing a more accurate assessment of flaw morphology and potentially improving the reliability of fitness-for-service evaluations.
Techniques involved
The ultrasonic and signal processing techniques developed were:
- Acquisition of ultrasonic signals using the FMC technique
- Real-time surface mapping of components using the FMC acquired data
- Real time focal law updates to accommodate changes in surface profile.
- Signal processing methods to calculate beam paths through refractive boundaries.
Experimental setup
To illustrate the effectiveness of the technique a part was manufactured with a profile of complex geometry, with which the FMC imaging system was provided with no prior knowledge. This component is shown in Figure 1. Custom FMC software was developed where the FMC imaging algorithm was used to image the component before and after accounting for the boundary. These results are shown in Figure 2.
Future potential
The technique shows promise to deliver fast and accurate defect detection and characterisation, beyond what is currently achievable. Future work includes extending the capabilities of current auto-focus algorithms; converting algorithms for commercial application; and developing a robust, portable hardware system for on-site inspection.
For more information please contact us.